Home › Fault codes › P15AB00
P15AB00 — Clutch position sensor – signal implausible
Clutch position sensor – signal implausible. The Taycan report this code; below is which control unit sets it on each model and how to read and clear it.
Which models and control units set P15AB00
How to read and clear P15AB00
- Plug a standard ENET (Ethernet-to-OBD) cable into your Porsche's OBD port and your Mac or Windows PC.
- Open STEUER14, pick your car and run a fault scan: every control unit is read, and P15AB00 shows with its status, its full description and the freeze frame when the unit stores one.
- Fix the cause first, then clear the fault memory and scan again to check it stays away. Reading and clearing fault codes is free on every control unit.
More about fault memory in the manual →
Download STEUER14 — free fault readingOther codes of the Engine Control Module 1
| P133600 | Electric machine speed control - deviation during shifting |
| P138800 | Engine electronics (DME) control unit – defective |
| P13FD00 | (Transmission oil) temperature sensor – rate of change too high |
| P150300 | Load signal terminal DF of Generator, Implausible signal |
| P150B00 | Insufficient acceleration/deceleration |
| P15A400 | Vehicle shutdown active |
| P15E200 | Clutch position sensor – signal implausible |
| P160900 | Crash switch-off was triggered |
| P162400 | Engine control indicator light switched on |
| P164000 | Function restriction |
| P164700 | Engine electronics (DME) control unit – coding defective |
| P168200 | Engine electronics (DME) control unit – implausible message from PSM |
All 274 codes of this control unit →
Fault names come from the manufacturer's diagnostic data. STEUER14 is independent and not affiliated with Porsche AG. A code tells you what a control unit detected, not always which part failed — check wiring, supply voltage and related codes before replacing parts. STEUER14 shows each fault's full description, status and freeze frame on the car.