Home › Fault codes › P133500

P133500 — Electric machine speed control - deviation during upshift

Electric machine speed control - deviation during upshift. The Taycan report this code; below is which control unit sets it on each model and how to read and clear it.

Which models and control units set P133500

Porsche Taycan

Engine Control Module 1

How to read and clear P133500

  1. Plug a standard ENET (Ethernet-to-OBD) cable into your Porsche's OBD port and your Mac or Windows PC.
  2. Open STEUER14, pick your car and run a fault scan: every control unit is read, and P133500 shows with its status, its full description and the freeze frame when the unit stores one.
  3. Fix the cause first, then clear the fault memory and scan again to check it stays away. Reading and clearing fault codes is free on every control unit.

More about fault memory in the manual →

Download STEUER14 — free fault reading

Other codes of the Engine Control Module 1

P089400Coasting (transmission) – mechanical fault
P091900Selector support - fault
P094900Servo motor (clutches) – adaptation values incorrect
P10F000Release line for starter generator, Open circuit
P10F100Release line for starter generator, Short circuit to B+
P10F200Release line for starter generator, Short circuit to ground
P133600Electric machine speed control - deviation during shifting
P138800Engine electronics (DME) control unit – defective
P13FD00(Transmission oil) temperature sensor – rate of change too high
P150300Load signal terminal DF of Generator, Implausible signal
P150B00Insufficient acceleration/deceleration
P15A400Vehicle shutdown active

All 274 codes of this control unit →

Fault names come from the manufacturer's diagnostic data. STEUER14 is independent and not affiliated with Porsche AG. A code tells you what a control unit detected, not always which part failed — check wiring, supply voltage and related codes before replacing parts. STEUER14 shows each fault's full description, status and freeze frame on the car.