Home › Fault codes › P215C00
P215C00 — Speed sensor, transmission output – signal implausible
Speed sensor, transmission output – signal implausible. The Taycan, 911 (992), Panamera (971) and Panamera (972) report this code; below is which control unit sets it on each model and how to read and clear it.
Which models and control units set P215C00
How to read and clear P215C00
- Plug a standard ENET (Ethernet-to-OBD) cable into your Porsche's OBD port and your Mac or Windows PC.
- Open STEUER14, pick your car and run a fault scan: every control unit is read, and P215C00 shows with its status, its full description and the freeze frame when the unit stores one.
- Fix the cause first, then clear the fault memory and scan again to check it stays away. Reading and clearing fault codes is free on every control unit.
More about fault memory in the manual →
Download STEUER14 — free fault readingOther codes of the Drive Motor Control Module
| P0EED00 | High-voltage system – discharging fault |
| P151B00 | Engine electronics (DME) control unit – voltage at terminal 15 on ignition off |
| P160900 | Crash switch-off was triggered |
| P164700 | Engine electronics (DME) control unit – coding defective |
| P171900 | Rotor position sensor – position implausible |
| P186100 | Engine electronics (DME) control unit – signal implausible |
| P2D2A00 | Medium-temperature circuit – temperature implausible (TW5/TW9/TW10) |
| P33CA00 | Programming |
| P33D700 | High-voltage power electronics phase control - internal fault |
| U002800 | Hybrid CAN bus – faulty |
| U002900 | Hybrid CAN bus - no communication |
| U008000 | FlexRay data bus - synchronization |
All 143 codes of this control unit →
Fault names come from the manufacturer's diagnostic data. STEUER14 is independent and not affiliated with Porsche AG. A code tells you what a control unit detected, not always which part failed — check wiring, supply voltage and related codes before replacing parts. STEUER14 shows each fault's full description, status and freeze frame on the car.