Home › Fault codes › C10ACF0
C10ACF0 — Steering, End stops not learned
Steering, End stops not learned. The Taycan, 911 (992), Panamera (971), Panamera (972) and Cayenne report this code; below is which control unit sets it on each model and how to read and clear it.
Which models and control units set C10ACF0
How to read and clear C10ACF0
- Plug a standard ENET (Ethernet-to-OBD) cable into your Porsche's OBD port and your Mac or Windows PC.
- Open STEUER14, pick your car and run a fault scan: every control unit is read, and C10ACF0 shows with its status, its full description and the freeze frame when the unit stores one.
- Fix the cause first, then clear the fault memory and scan again to check it stays away. Reading and clearing fault codes is free on every control unit.
More about fault memory in the manual →
Download STEUER14 — free fault readingOther codes of the Steering Assist
| B2F1F00 | Development code 31 |
| C10A700 | Rolling test mode active |
| C10AA29 | Steering torque sensor - implausible signal |
| C10AA31 | Steering torque sensor, No signal |
| C10AB01 | Steering torque sensor supply voltage - electrical fault |
| C10AC07 | Steering, mechanical malfunction |
| C10ACF1 | Steering, incorrect ratio |
| C10ACF8 | Steering, Limit value exceeded |
| C10AD29 | Motor position sensor - implausible signal |
| C10AE01 | Electromechanical power steering motor, Electrical error |
| C10AE04 | Electromechanical power steering motor, Faulty |
| C10AE13 | Electromechanical power steering motor, Open circuit |
All 133 codes of this control unit →
Fault names come from the manufacturer's diagnostic data. STEUER14 is independent and not affiliated with Porsche AG. A code tells you what a control unit detected, not always which part failed — check wiring, supply voltage and related codes before replacing parts. STEUER14 shows each fault's full description, status and freeze frame on the car.